Part Number Hot Search : 
B23N15 TP120 2SC22 AD5011B 210L4 PIC12F PM200 MK105
Product Description
Full Text Search
 

To Download TPDC250P-48B-490O Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 TOTAL POWER INT'L 36-72VDC INPUT RANGE DC-DC CONVERTER HOT-SWAP
CompactPCI QUAD OUTPUT 250 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES TPDC250P-48B SERIES
FEATURES:
250W 3U X 8HP EUROCARD PACKAGE 36-72VDC NOMINAL 48VDC INPUT INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS B CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 36-72Vdc,nominal input 48Vdc. Input Connector: Positronic 47-pin PCIH47M400A1. Inrush Current: Typ. 20A @ nominal 48Vdc. Input Current: 6.6A @ nominal input 48Vdc. Dielectric Withstand: Meet IEC950 regulation. EMI: Meet EN55022 / FCC Class B. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection (OTP): Installed NTC for thermal sensor at [DEG#] pin. Overload Protection (OLP): Fully protected against output overload or short circuit. Typical 120% max. load. Consult the factory for special OLP setting. Over Current Protection (OCP): Installed in each rail.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 250W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: Typ. 2.0%. Noise & Ripple: Typ. 1% Pk.-Pk. or 50mV,which is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1,2&3. Output Trim: Electrical trim available at VO1 & 2.[ADJ #]. Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs for N+1 redundancy operation. Current Sharing: Third-wire current sharing at VO1,2&3. Power OK Signal: Available for all outputs. Operating Temperature: 0 to +50 C at full load with specified air flow. Deraes linearly to 50% at +70C. Storage Temperature: -40 to +85 C. Temperature Coefficient: Typ. 0.02% / C. Cooling: At least 16 cfm (500 lfm) moving air is required to achieve full rating power 250W in a confined area. Power Density: 4.58 Watts/ Cubic Inch.
GENERAL SPECIFICATION
Efficiency: Typ. 79 %. Switching Frequency: 120K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 100mV and recovers within 2mS for 25% load-change. Safety Standard: IEC60950. Construction: Eurocard 3U X 8HP X 160mm CompactPCI format. Front panel with either Ordinary handle or Extractor handle.
Remark: All measurements are at nominal input, full load and +25C unless otherwise specifications.
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1-
OUTPUT VOLTAGE/CURRENT RATINGS CHART
QUAD OUTPUT
MODEL NO. TPDC250P-48B-490(E) MAIN +VO1 @# AUX. +VO2 @# Typ. 18A 18A AUX. +VO3 @# AUX. -VO4 = Min. Typ. Volt. Max. Min 2.0A 25A +5V +5V 33A 33A 0A 0A Volt. Max. Min. +3.3V 33A +3.3V 33A 0A 0A Typ Volt. Max Pk. Min. Typ. Volt. Max. Pk. 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A
TPDC250P-48B-490(O) 2.0A 25A
Symbol: "" OVP built-in. "@" Adjustable. "#" Remote sensing. "" 3rd wire Load Sharing. "" Installed with Or-ing diode. "" Magnetic Amplifier. "" Installed with Post-regulator. "" Common Choke. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 666.0 g (23.5 Oz.)
TPDC250P-48B-490(E)
TPDC250P-48B-490(O)
INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT
DC INPUT ASSIGNMENT -Vin +Vin G CNTR &PIN # 47 46 45 QUAD OUTPUT VO1 1,2, 3,4 S+ 30 S- Adj. C.S. 34 29 35 VO2 13,14, 15,16, 17,18 S+ 33 Adj. C.S. 32 41 VO3 20 S+ 36 C.S 44 VO4 21 DC COM EN# 5,6,7,8,9, 27 10,11,12, 19,22,24 STATUS/CONTROL DEG# 38 INH# FAL# 39 42
Mating connector: PCIH47F400A1.
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -2-


▲Up To Search▲   

 
Price & Availability of TPDC250P-48B-490O

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X